Explorer Sport Trac 4WD V6-4.0L VIN K Flex Fuel (2004)
Using the special tool, remove the crankshaft pulley bolt.
4. NOTE: If the crankshaft pulley bolt is not installed, the special tool will bottom out before the pulley is off.
Install the crankshaft pulley bolt 2-3 turns. Using the special tool and the 8 mm x 1.25 x 100 mm bolts, remove the pulley.
Installation
1. NOTE: If not secured within four minutes, the sealant must be removed and the sealing area cleaned. To clean the sealing area, use silicone
gasket remover and metal surface prep. Follow the directions on the packaging. Failure to follow this procedure can cause future oil leakage.
Apply silicone gasket and sealant to the Woodruff key slot on the crankshaft pulley.
2. Using the special tool, install the crankshaft pulley.
