Explorer Sport Trac 4WD V6-4.0L VIN K Flex Fuel (2004)
1. NOTE: Make sure the mounting bracket and front impact severity sensor mating surfaces are clean and debris free before installation.
Align the locator tabs to the holes in the bracket.
2. Install the front impact severity sensor.
1
With the locator tabs aligned to the holes in the bracket, position the sensor in place.
2
Install the bolt.
3
Connect the front impact severity sensor.
3. Install the header opening panel and the scrivets.
4. Repower the SRS.
Front Row Side Impact Sensor
SIDE IMPACT SENSOR - FRONT ROW
REMOVAL
WARNING:
-
Vehicle sensor orientation is critical for correct system operation. If a vehicle equipped with an air bag supplemental restraint system
(SRS) is involved in a collision, inspect the sensor mounting bracket and wiring pigtail for deformation. Replace and correctly position
the sensor or any other damaged supplemental restraint system (SRS) components whether or not the air bag is deployed.
-
Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag module.
This will reduce the risk of injury in the event of an accidental deployment.
-
To reduce the risk of personal injury, do not use any memory saver devices.
NOTE:
-
The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate
a supplemental restraint system (SRS) fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.