Explorer Sport Trac 4WD V6-4.0L VIN K Flex Fuel (2004)
Wheel Speed Sensor: Service and Repair
Sensor, Rear
Material
Material
Removal and Installation
1. Raise and support vehicle.
2. NOTE: Clean off dirt and foreign material that may have collected around the rear anti-lock brake sensor before removal.
Remove the rear anti-lock brake system (ABS) sensor.
1
Disconnect the electrical connector.
2
Remove the bolt.
3
Remove the sensor.
3. NOTE: Thoroughly clean the mounting surface.
NOTE: Inspect the anti-lock brake sensor O-ring for damage; lightly lubricate the O-ring with axle lubricant.
To install, reverse the removal procedure.
