Explorer Sport Trac 4WD V6-4.0L VIN K Flex Fuel (2004)
at the 3 o'clock position when viewed from the rear.
NOTE: Inspect the counterbore of the extension housing for burrs. Remove any burrs from the extension housing counterbore with an oil stone.
Position the extension housing bushing into the extension housing.
2. CAUTION: The tool will bottom when bushing is in the correct position.
Using the special tool, install the extension housing bushing.
3. Position new extension housing seal with drain hole in the 6 o'clock position.
4. Using the special tool, install the extension housing seal.
5. NOTE: Inspect the driveshaft slip-yoke for wear and damage. install a new component if required.
