Explorer Sport Trac 4WD V6-4.0L VIN K Flex Fuel (2004)
Transmission Mount: Service and Repair
Transmission Insulator and Retainer
Removal
NOTE: 4x2 procedure shown. 4x4 similar, front drive shaft will need to be removed.
1. With the vehicle in NEUTRAL, position it on a hoist.
2. NOTE: To maintain initial driveshaft balance, mark the rear driveshaft yoke and axle flange so they may be installed in their original alignment.
Mark the rear driveshaft.
3. Remove the rear driveshaft.
1. Remove the bolts.
2. Remove the rear driveshaft.
4. Remove the transmission mount nuts.
