Explorer Sport Trac 4WD V6-4.0L VIN K Flex Fuel (2004)
Back Window Glass: Service and Repair
Rear Window Positioning
REAR WINDOW POSITIONING
CAUTION:
-
Make sure that no obstructions are present in the power rear window system when carrying out this procedure.
-
If the glass/regulator system is binding, the system must be diagnosed and a new component must be installed. Do not apply hand
pressure to glass that does not move freely.
NOTE:
-
Because the power rear window removal/installation position is approximately three-quarters down and the power rear window motor can only
move the window to three positions, a special procedure is necessary to position the window to the removal/installation position.
-
If the power rear window motor does not respond to this procedure, refer to the diagnosis and testing for repair. If the window must be removed
and the window motor does not respond to this procedure, remove the window motor. The window then can be moved by carefully applying hand
pressure in the downward direction.
-
By only partially carrying out the power rear window motor initialization procedure, the window motor will enter error mode. In error mode, no
window motor movement is possible and the window motor will have to be reinitialized. Refer to Rear Window Motor Initialization.
-
The key-in-ignition chime can cause the vent button to be pressed more or less than six times due to the distraction of the chime.
1. NOTE: Steps 1-6 must be completed within 30 seconds.
Start with the ignition in the OFF position. Open the driver door.
2. Turn the ignition to the ON position.
3. Press the power rear window control switch vent button six times.
4. Turn the ignition to the OFF position. The driver door must be open.
