Explorer Sport Trac 4WD V8-4.6L (2008)
Part 2
Removal and Installation
1. Remove the rear door trim panel.
2. Remove the rear door speaker.
3. Remove the interior moulding.
4. Remove the rear door weather shield.
5. CAUTION: Make sure the hole in the glass bracket does not become enlarged during the rivet removal process. Damage to the window
regulator will occur if the hole becomes enlarged. The new rivet may become loose, resulting in a clicking noise concern.
NOTE: Use a 4.5 mm (0.1772 in) drill bit to drill out the glass-to-regulator rivets.
Remove the rear door window glass-to-regulator rivet.
-
Position the rear door window glass as necessary to access the rear door window glass-to-regulator rivet.
6. Secure the rear door window glass in the full up position with tape.
7. Disconnect the window regulator motor electrical connector.
8. Remove the 2 rear window regulator mounting nuts.
-
To install, tighten to 10 Nm (89 lb-in).
9. Remove the 3 window regulator motor bracket nuts.
-
To install, tighten to 10 Nm (89 lb-in).
10. Remove the window regulator assembly.
11. To install, reverse the removal procedure.
