Explorer Sport Trac 4WD V8-4.6L (2008)
Wheel Speed Sensor: Service and Repair
Wheel Speed Sensor - Rear
Wheel Speed Sensor - Rear
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Disconnect the wheel speed sensor electrical connector.
3. Disconnect the wheel speed harness from the retainers.
4. Remove the wheel speed sensor bolt and the wheel speed sensor.
^
To install, tighten to 8 Nm (71 lb-in).
5. To install, reverse the removal procedure.
