Explorer Sport Trac 4WD V8-4.6L (2008)
-
Using an oil filter strap wrench, tighten the filter an additional 270 degrees.
7. Remove the 4 bolts and the oil filter adapter.
^
To install, tighten to 25 Nm (18 lb-ft).
8. CAUTION: Do not use metal scrapers, wire brushes, power abrasive discs or other abrasive means to clean the sealing surfaces. These
may cause scratches and gouges resulting in leak paths. Use a plastic scraper to clean the sealing surfaces.
Remove and discard the oil filter adapter gasket.
^
Clean the sealing surfaces with silicone gasket remover and metal surface prep. Follow the directions on the packaging.
^
Inspect the mating surfaces.
9. To install, reverse the removal procedure.
^
Fill the engine with clean engine oil.
10. Fill and bleed the engine cooling system.
