Explorer Sport Trac 4WD V8-4.6L (2008)
Removal and Installation
1. Remove the audio control module (ACM).
2. Lower the glove compartment.
3. Remove the 3 center panel duct screws and position the center panel duct aside.
4. Remove the 2 plenum chamber screws.
5. Disconnect the panel door vacuum control motor vacuum connector.
6. Remove the 2 panel door vacuum control motor screws.
7. NOTE: The plenum chamber must be slightly repositioned to allow the panel door vacuum control motor to be rotated far enough to clear the
retaining arm.
Rotate the panel door vacuum control motor until it clears the retaining arm and remove the panel door vacuum control motor.
8. To install, reverse the removal procedure.
