Explorer Sport Trac 4WD V8-4.6L (2008)
5. If the evaporator core orifice is broken, screw the end of the special tool into the broken orifice. Hold the T-handle stationary while rotating the
tool body to remove the evaporator core orifice.
Installation
1. Lubricate the evaporator core orifice O-rings with clean PAG oil and install the evaporator core orifice using the special tool.
2. Install a new O-ring seal and connect the evaporator core orifice access fitting.
-
To install, tighten to 18 Nm (13 lb-ft).
3. Lubricate the refrigerant system with the correct amount of clean PAG oil.
4. Evacuate, leak test and charge the refrigerant system.
