Explorer Sport Trac 4WD V8-4.6L (2008)
-
To install, tighten to 8 Nm (71 lb-in).
9. NOTE: The LH clip should be disconnected from the line. The RH clip should be disconnected from the cooling module.
Detach the 2 compressor-to-condenser discharge line clips at the cooling module.
10. Remove the compressor-to-condenser discharge line.
11. To install, reverse the removal procedure.
-
Install a new gasket seal and O-ring seals.
-
Lubricate the refrigerant system with the correct amount of clean PAG oil.
12. Evacuate, leak test and charge the refrigerant system.
