Explorer Sport Trac 4WD V8-4.6L (2008)
Hose/Line HVAC: Service and Repair
Condenser To Evaporator Line
CONDENSER TO EVAPORATOR LINE
Removal and Installation
All vehicles
1. Remove the air cleaner (ACL) and ACL outlet tube.
2. Recover the refrigerant.
3. Remove the PCM and PCM bracket.
4. Disconnect the RH wheel speed sensor electrical connector and detach the wire harness from the condenser-to-evaporator line bracket.
Vehicles equipped with 4.6L engine
5. Remove the suction accumulator-to-compressor line bracket nut.
-
To install, tighten to 7 Nm (62 lb-in).
All vehicles
6. Disconnect the evaporator core orifice access fitting.
-
Discard the O-ring seal.
7. Remove the condenser-to-evaporator line bracket nut.
-
To install, tighten to 7 Nm (62 lb-in).
