Explorer Sport Trac 4WD V8-4.6L (2008)
9. Install the outer manual lever and nut.
^
Tighten to 48 Nm (35 lb-ft).
10. NOTE: When installing the selector lever cable, make sure that the selector lever cable locking tabs are locked in place and the selector lever
cable end is snapped onto the ball stud. Press the selector lever cable into the selector lever cable bracket and listen for the selector lever cable to
click in place. Pull back on the selector lever cable to make sure that it is locked into the selector lever cable bracket. Also make sure that the
selector lever cable end is correctly installed onto the ball stud. Pull back on the selector lever cable end to make sure that the selector lever cable
end is correctly installed.
Install the selector lever cable end onto the manual control lever.
11. Reconnect the digital TR sensor electrical connector.
