Explorer Sport Trac 4WD V8-4.6L VIN 8 (2007)
-
If the inboard recliner is not positioned to the recliner stop (or any upright position), when the outboard recliner is positioned to the recliner
stop and the release strap is let go of, the recliners will not lock in place.
Pull the release strap at the outboard recliner and position the outboard recliner pin to contact the recliner stop. Let go of the release strap and
the inboard and outboard recliners will lock in place.
-
Each recliner pin must contact the recliner outer plate (stop).
5. Position the backrest assembly to the inboard and outboard recliners and hand start the 2 inboard and 2 outboard recliner-to-backrest frame bolts.
6. CAUTION: The recliner-to-backrest frame bolts must be tightened in sequence or recliner latches that do not lock in place or binding
may occur.
Install the recliner-to-backrest frame bolts in the following sequence:
1. Install the inboard recliner-to-backrest frame upper bolt.
-
Tighten to 55 Nm (41 lb-ft).
2. Install the inboard recliner-to-backrest frame lower bolt.
-
Tighten to 55 Nm (41 lb-ft).
3. Install the outboard recliner-to-backrest frame upper bolt.
-
Tighten to 55 Nm (41 lb-ft).
4. Install the outboard recliner-to-backrest frame lower bolt.
-
Tighten to 55 Nm (41 lb-ft).
7. Position the kneeling mechanism release handle and cable back through the backrest frame and backrest trim cover openings.
-
Attach the kneeling mechanism release cable to the backrest frame.
8. Roll the backrest trim cover down, attach the hook-and-loop strips and connect the backrest trim cover lower J-clip.
9. Position the kneeling mechanism release handle to the backrest opening and push in, engaging the clips.
10. Route the outboard recliner release strap before installing the outboard recliner outer cover.
11. Install the outboard recliner outer cover.
-
Position the outboard recliner outer cover.
-
Route the release strap through the cover.
-
Install the 2 screws.
-
Install the recliner handle.
-
Install the screw.
12. Position the inboard recliner outer cover and install the 2 screws.
13. Install the second row, 40 percent E-Z entry seat into the vehicle.
14. Cycle the backrest down and then back to the upright position. Make sure the inboard and outboard recliners simultaneously and securely lock in
the upright position.
Seat Backrest - Second Row, 60 Percent, E-Z Entry
SEAT BACKREST - SECOND ROW, 60 PERCENT, E-Z ENTRY
