Explorer Sport Trac 4WD V8-4.6L VIN 8 (2007)
5.
Zip ties on both the die cast end fitting and conduit end fitting can now be pulled tight and the excess slack can be cut off. (Figures 4 and 5)
6.
To install the lumbar strap assembly, reverse the removal procedure.
NOTE
THE LUMBAR ATTACHMENT WIRES MUST BE RUN IN AND BACK OUT OF THE LANCE TABS ON THE BACK FRAME. (Figure 6)
7.
Install the front seat and repower the SRS. If a passenger seat has been serviced, do not prove out the SRS at this time. For additional information,
refer to WSM, Section 501-10.
8.
On Explorer and Explorer Sport Trac vehicles carry out the Occupant Classification Sensor (OCS) System Zero Weight Test and prove out the
(SRS). Refer to WSM, Section 501-20B General Procedures.
Parts Block
WARRANTY STATUS: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage IMPORTANT: Warranty coverage limits/policies are
not altered by a TSB. Warranty coverage limits are determined by the identified causal part.
OPERATION
DESCRIPTION
TIME
070703A
2006-2007 Fusion/Milan
1.5 Hrs.
With Manual Lumbar Seat:
Replace The Lumbar
Strap, Includes Time To
Depower And Repower
The Supplemental
