Explorer Sport Trac 4WD V8-4.6L VIN 8 (2007)
Third Row Seat Cushion (Part 2)
Exploded View
Removal and Installation
1. Position the backrest to the upright position.
2. Remove the third row seat from the vehicle.
3. NOTE: The backrest must be up to access the bolts.
Remove the latch-to-cushion frame bolt and the hinge-to-cushion frame bolt.
-
To install, tighten to 25 Nm (18 lb-ft).
4. From under the front of the cushion frame, release the cushion trim cover from the studs to access the 2 cushion pivot link assembly-to-cushion
frame nuts.
5. Remove the 2 cushion pivot link assembly-to-cushion frame nuts. Remove the cushion assembly.
-
To install, tighten to 22 Nm (16 lb-ft).
6. To install, reverse the removal procedure.
