Explorer Sport Trac 4WD V8-4.6L VIN 8 (2007)
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair
2. Remove the battery tray.
3. Disconnect the anti-lock brake system (ABS) module electrical connector.
4. NOTE: The brake tubes must be installed in the same location as removed.
Remove the 2 brake tube-to-hydraulic control unit (HCU) fittings and position the brake tubes aside.
^
To install, tighten to 23 Nm (17 ft. lbs.).
5. NOTE: The brake tubes must be installed in the same location as removed.
Remove the 4 brake tube-to-HCU extension tube fittings.
^
To install, tighten to 18 Nm (13 ft. lbs.).
6. Remove the 3 HCU bracket-to-frame nuts.
^
To install, tighten to 23 Nm (17 ft. lbs.).
7. Remove the HCU assembly.
8. NOTE: The brake tubes must be installed in the same location as removed.
Remove the 4 HCU extension tube-to-HCU fittings.
^
To install, tighten to 18 Nm (13 ft. lbs.).
9. Remove the 2 HCU bracket-to-HCU extension tube retainer nuts and the extension tube retainer assembly.
^
To install, tighten to 9 Nm (80 inch lbs.).
10. Remove the bracket-to-HCU bolts and the HCU bracket.
^
To install, tighten to 9 Nm (80 inch lbs.).
11. To install, reverse the removal procedure.
^
Bleed the brake system.