Explorer Sport Trac 4WD V8-4.6L VIN 8 (2007)
7. Place a thin bead of Motorcraft(R) Silicone Gasket and Sealant on center section of the underside of the brake pad slippers. (Figure 2)
8. Install the brake pad slippers on to the caliper rails. The smaller brake pad slipper is attached to the upper caliper rail. The larger brake pad slipper is
attached to the lower caliper rail with the anti rattle loop facing away from the rotor. (Figure 3)
9. Clean any excess Motorcraft(R) Silicone Gasket and Sealant off of the slippers.
10. Remove the caliper pin sleeves and rubber boots.
11. Install new pin caliper boots.
12. Place caliper slide grease into the pin sleeve boots.
13. Install caliper slide pin into the rubber boots.
14. Clean any excess grease off of caliper.
15. Install inner and outer brake pads.
NOTE
THE BRAKE PADS ARE LABELED L FOR LEFT SIDE AND R FOR RIGHT SIDE ON THE STEEL BACKING PLATE.
16. Install brake caliper as per WSM, Section 206-04.
17. Repeat steps 2-16 on the other side.
18. Install the rear tires as per the WSM, Section 204-04.
