Explorer Sport Trac 4WD V8-4.6L VIN 8 (2007)
^
To install, tighten to 25 Nm (18 ft. lbs.).
7. Remove the generator bracket-to-coolant crossover bolts, and position the generator, bracket and wiring harness aside as an assembly.
^
To install, tighten to 10 Nm (89 inch lbs.).
8. Disconnect the PCV heater hose from the coolant crossover manifold assembly.
9. Disconnect the heater hose from the coolant crossover manifold assembly.
10. Disconnect the upper radiator hose from the coolant crossover manifold assembly.
11. Remove the bolts, the coolant crossover manifold assembly and the gaskets. Discard the gaskets.
^
To install, tighten to 10 Nm (89 inch lbs.).
12. To install, reverse the removal procedure.
^
Install new gaskets.
