Explorer Sport Trac 4WD V8-4.6L VIN 8 (2007)
Removal
CAUTION: Suspension fasteners are critical parts because they affect performance of vital parts and systems and their failure can result in
major service expense. A new part with the same part number must be installed if installation becomes necessary. Do not use a replacement
part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of correct retention of
these parts.
CAUTION: Orientation of the suspension fasteners is important. Make sure the fasteners are installed in the same direction as they were in
when removed.
1. With vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. CAUTION: Care must be used when servicing rear brake components without disconnecting the parking brake cable from the brake
caliper lever. Carefully position the caliper aside using a suitable support or damage to the parking brake cable end fittings can occur.
CAUTION: Do not allow the caliper and anchor plate assembly to hang from the brake hose or damage to the hose can occur.
Remove the bolts and position the brake caliper aside.
^
Support the caliper using mechanic's wire.
3. Remove the brake disc.
4. Remove the parking brake shoe adjuster spring and adjuster.
5. CAUTION: The brake shield has an access hole knockout that must be removed to allow for the removal of the wheel stud.
Using a suitable punch, remove the access hole cover from the brake shield.
6. NOTE: Make sure that the wheel stud is aligned with the recessed area of the wheel knuckle.
Using the special tool, press the wheel stud until it makes contact with the edge of the wheel knuckle.
