Explorer Sport Trac 4WD V8-4.6L VIN 8 (2007)
3. Separate the quick connect coupling from the fitting.
Connect - Type III
1. Inspect the quick connect coupling and the tube for damage. Remove any dirt or obstructions.
2. CAUTION: Make sure the fuel tube clicks into place when installing the tube. To make sure that the fuel tube is fully seated, pull on the
tube.
NOTE: Apply clean engine oil to O-ring seals.
Release the locking tab and install the quick connect coupling onto the fitting.
3. Position the locking tab into the latched position.
Disconnect - Type IV
WARNING:
-
The evaporative emissions system contains fuel vapor and condensed fuel vapor. Although not present in large quantities, it still presents
danger of explosion or fire. Disconnect the battery ground cable from the battery to minimize the possibility of an electrical spark
occurring, possibly causing a fire or explosion if fuel vapor or liquid fuel are present in the area. Failure to follow these instructions may
result in personal injury.
-
Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel-related component. Highly flammable
mixtures are always present and may be ignited. Failure to follow these instructions may result in personal injury.
-
Fuel in the fuel system remains under high pressure even when the engine is not running. Before repairing or disconnecting any of the
fuel lines or fuel system components, the fuel system pressure must be relieved to prevent accidental spraying of fuel, which can cause a
fire hazard. Failure to follow these instructions may result in personal injury.
-
Do not carry personal electronic devices such as cell phones, pagers or audio equipment of any type when working on or near any
