Explorer Sport Trac 4WD V8-4.6L VIN 8 (2007)
Variable Induction Control Actuator: Service and Repair
CHARGE MOTION CONTROL VALVE (CMCV)
Removal
1. Remove the intake manifold.
2. NOTE: Do not disconnect the linkages at the intake manifold unless a new intake manifold is being installed.
Remove and discard the 2 E-clips and disconnect the charge motion control valve (CMCV) linkages from the CMCV.
3. NOTE: Bent shaft or damaged components will require a new intake manifold.
Rotate each CMCV shaft by hand to verify that they do not stick or bind.
4. Remove the 3 bolts and the CMCV.
Installation
1. Position the CMCV and loosely install the 3 bolts.
-
Do not tighten the bolts at this time.
2. Rotate each CMCV shaft so that the plates are in the closed position.
