Explorer Sport Trac 4WD V8-4.6L VIN 8 (2007)
(1)
Choose all Tests and Calibrations.
(2)
Scroll down the menu and Choose Reset TCM KAM.
NOTE
FOR PDS, RESET TCM KAM IS NOT THE SAME AS CLEAR TRANSMISSION ADAPTIVE TABLES, WHICH IS UNDER THE
POWERTRAIN - TRANSMISSION MENU TREE.
NOTE
UNHOOKING THE BATTERY WILL NOT CLEAR THE TCM KAM.
NOTE
DO NOT CLEAR THE PCM KAM.
(3)
Verify that the transmission fluid temperature (TFT) PID is above 175 °F (80 °C).
4.
If it is not at 175 °F (80 °C), drive unit approximately 3 miles (5 Km) to reach temperature.
NOTE
TFT MUST BE AT 175 °F (80 °C) OR ABOVE BEFORE PROCEEDING TO STEP 5.
5.
Drive unit to perform adaptive shift strategy learn.
a.
Accelerate from rest with light throttle to 15 MPH (24 Km/h), remove foot from accelerator pedal.
b.
Brake very gently to a complete stop (allow at least six (6) seconds).
c.
Repeat steps (a-b) five (5) times in the dealership parking lot or similar setting.
d.
Continue to accelerate until you achieve 50 MPH (80 Km/h) or the 5-6 upshift.
e.
Accelerate from rest with light throttle. The 1-2, 2-3, and 3-4 shifts must occur at engine speeds between 1300-1800 RPM.
f.
Continue to accelerate gently to 50 MPH (80 Km/h) or the 5-6 upshift.
g.
Brake gently to a complete stop and hold foot on brake for at least 10 seconds.
h.
Repeat Steps (e-f) a total of three (3) times.
NOTE
AUTHORIZATION DECAL NOT REQUIRED.
WARRANTY STATUS: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage And Emissions Warranty Coverage
IMPORTANT: Warranty coverage limits/policies are not altered by a TSB. Warranty coverage limits are determined by the identified causal part.
OPERATION
DESCRIPTION
TIME
090102A
2006-2008 Explorer,
0.3 Hr.
Mountaineer 2007-2008
Explorer Sport Trac 4.0L
Engine: Check DTCs,
Reprogram The PCM (Do
Not Use With 12650D)
090102B
2006-2008 Explorer,
1.0 Hr.
Mountaineer 2007-2008
Explorer Sport Trac 4.6L
Engine: Check DTCs,
Reprogram The PCM And
TCM, Includes Time To
Clear KAM And Perform
Road Tests (Do Not Use
With 12650D)
