Explorer Sport Trac 4WD V8-4.6L VIN 8 (2007)
Electronic Brake Control Module: Customer Interest
ABS/TCS/RCS - Warning Lamp ON/DTC C1440 Set
TSB 06-6-9
04/03/06
ANTI-LOCK BRAKE SYSTEM / TRACTION CONTROL /
ROLL STABILITY CONTROL INDICATOR (ABS / TC /
RSC) WARNING LAMP ON WITH DTC C1440
FORD:
2006 Explorer
2007 Explorer Sport Trac
MERCURY:
2006 Mountaineer
ISSUE
Some 2006 Explorer 4dr / Mountaineer and 2007 Sport Trac vehicles built through 3/16/2006 may exhibit an anti-lock brake system / traction control /
roll stability control (ABS / TC / RSC light) warning lamp illuminated with diagnostic trouble code C1440 pressure transducer main / primary signal
faulted. This may be caused by the integrated control unit (ICU).
ACTION
Follow the Service Procedure to determine if the ABS module needs to be replaced.
NOTE
THE BASE BRAKE SYSTEM CONTINUES TO FUNCTION PROPERLY.
SERVICE PROCEDURE
1.
Install scan tool, retrieve DTCs and record.
a.
If DTC C1440 is retrieved, proceed to Step 2.
b.
If DTC C1440 is not retrieved, this TSB does not apply. Proceed with normal diagnostics.
2.
Replace the ABS module (2C219). Refer to Workshop Manual, Section 206-09 for Removal and Installation procedure.
Parts Block
WARRANTY STATUS: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage
DEALER CODING
CONDITION
BASIC PART NO.
CODE
2C219
42
Disclaimer
