Explorer Sport Trac 4WD V8-4.6L VIN 8 (2007)
Seat Occupant Classification Module - Air Bag: Service and Repair
OCCUPANT CLASSIFICATION MODULE
Removal
WARNING:
-
Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag module.
This will reduce the risk of injury in the event of an accidental deployment.
-
To reduce the risk of personal injury, do not use any memory saver devices.
NOTE:
-
The air bag warning lamp illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal
operation and does not indicate a supplemental restraint system (SRS) fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
-
Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic
procedure again.
-
Power seat shown, manual similar.
-
Seat is removed for clarity.
1. Depower the system.
2. From underneath the front of the seat, disconnect the OCS module electrical connector.
3. NOTE: Note the position of the locator tab on the OCS module for installation.
Remove the 2 screws and the OCS module.
-
To install, tighten to 2 Nm (18 lb-in).
4. To install, reverse the removal procedure.
5. Repower the SRS. Do not prove out the SRS at this time.
