Explorer Sport Trac 4WD V8-4.6L VIN 8 (2007)
Impact Sensor: Description and Operation
SENSORS
WARNING:
-
The restraints control module (RCM) orientation is critical for correct system operation. If a vehicle equipped with an air bag
supplemental restraint system (SRS) has been involved in a collision in which the center tunnel area has been damaged, inspect the
mounting and bracket for deformation. If damaged, a new RCM must be installed whether or not the air bags have deployed. In addition,
make sure the area of the RCM mounting is restored to its original condition.
-
Vehicle sensor orientation is critical for correct restraint system operation. If a vehicle equipped with an SRS is involved in a collision,
inspect the sensor mounting bracket and wiring pigtail for deformation. Replace and correctly position the sensor or any other damaged
SRS components whether or not the air bag is deployed.
For these vehicles, the SRS uses up to 6 satellite sensors in addition to the RCM. The RCM is mounted to the center tunnel beneath the console. All
vehicles will have 2 front impact severity sensors located in the front-center area of the vehicle, behind the grille mounted on the lower radiator support.
The first row impact sensors are located in each of the front doors behind the trim panel. If the vehicle is equipped with safety canopies, there are 2
additional side impact sensors. The 2 additional sensors are located on each C-pillar. Mounting orientation and torque is critical for correct operation of
all impact and rollover sensors.
