Explorer Sport Trac 4WD V8-4.6L VIN 8 (2007)
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
-
Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic
procedure again.
1. Depower the system.
2. Remove the 4 pin-type retainers and the lower radiator air deflector.
3. WARNING: The tightening torque of the air bag front impact severity sensor retaining nuts is critical for correct system operation.
NOTE:
-
Make sure the radiator support and front impact severity sensor mating surfaces are clean and free of foreign material.
-
Note position of locator tab on sensor bracket for installation.
Remove the front impact severity sensor bolt.
-
To install, tighten to 12 Nm (9 lb-ft).
4. Disconnect the front impact severity sensor electrical connector and remove the sensor.
5. To install, reverse the removal procedure.
6. Repower the system.
