Explorer Sport Trac 4WD V8-4.6L VIN 8 (2007)
2. CAUTION: Push only on the tip of the occupant classification sensor (OCS) electrical connector release tab to release the electrical
connector. Do not insert the tool too deep into the OCS electrical connector or damage to the electrical connector may occur.
NOTE: Note the position and the routing of the OCS rail electrical wiring, connector and wiring retainers for installation.
On the affected side, detach the 2 OCS rail wiring retainers. Then using a suitable tool, release the tab and disconnect the OCS rail electrical
connector.
3. If equipped, disconnect the power seat track motor electrical connector.
4. Move the seat to the forward most position.
-
If equipped with a power seat track, apply power and ground to the pins shown.
5. Remove the 2 rear bolts from the affected OCS rail.
