Explorer Sport Trac 4WD V8-4.6L VIN 8 (2007)
Installation
All vehicles
1. CAUTION:
-
Do not reuse the TP sensor and screws. A new TP sensor and screws must be installed.
-
Do not use a high-speed driver to install the new screws or damage to the TP sensor can occur.
NOTE: When installing the new TP sensor, make sure that the radial locator tab on the TP sensor is aligned with the radial locator hole on the
throttle body.
Position the new TP sensor and install the 2 new screws.
-
Tighten to 3 Nm (27 lb-in).
2. Connect the TP sensor electrical connector.
Vehicles equipped with a 4.6L (3V) engine
3. Install a new O-ring seal, position the heated PCV fitting and install the bolts.
4. Install the air cleaner outlet pipe.
