ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Campaign - A/T Shift Lever Circuit Board Replacement|Page 931 > < Campaign - A/T Shift Lever Circuit Board Replacement|Page 929
Page 3
background image

^

Enter claims using Direct Warranty Entry (DWE).

^

Refund or related damage must be claimed on a repair line that is separate from the repair line on which the FSA is claimed. Related damage
requires prior approval from the Special Service Support Center.

^

"MT" labor should be submitted on a separate repair line with the related damage flag checked. "MT" labor requires prior approval from the
Special Service Support Center.

^

Refer to ACESII manual for claims preparation and submission information.

^

PROGRAM TERMS: This program will be in effect until January 31, 2011 regardless of mileage.

Attachment II - Labor and Parts Information

LABOR ALLOWANCES

PARTS REQUIREMENTS / ORDERING INFORMATION

Order your parts requirements through normal order processing channels.

The DOR/COR number for this recall is 50415.

DEALER PRICE

For latest prices, refer to DOES II.

PARTS RETENTION AND RETURN

Follow the provisions of the Warranty and Policy Manual for "Parts Retention and Return Procedures."

EXCESS STOCK RETURN

Excess stock returned for credit must have been purchased from Ford Customer Service Division in accordance with Policy Procedure Bulletin 4000.

Attachment III - Technical Information

OVERVIEW

In some of the affected vehicles, the transmission gearshift lever may not move out of the park position even when the brake pedal is depressed. This
"stuck in park" condition can develop due to silicon dioxide contamination building up on the contacts of the park detect switch located on the
transmission gearshift lever.

SERVICE PROCEDURE

1. Remove the front floor console. Refer to the appropriate WSM Section 501-12 Console - Front.

2. NOTICE: Electronic modules are sensitive to static electrical charges If the new circuit board is exposed to these charges, damage may result The

circuit board should be handled by the plastic connector(s) and avoid touching any of the metal surfaces.

Campaign - A/T Shift Lever Circuit Board Replacement|Page 931 > < Campaign - A/T Shift Lever Circuit Board Replacement|Page 929