Explorer Sport Trac 4WD V8-4.6L VIN 8 (2007)
Disassembly
CAUTION: Tire pressure sensors are manufactured in multiple colors based on their application. When installing a new sensor, make sure
the color of the sensor being installed matches the color of the sensor that was removed. The different colored sensors are not
interchangeable.
NOTE: The sensor is available separately, the cradle and strap are available as a strap kit. There are several different strap kits available based on
wheel diameter but all strap kits share the same base part number.
NOTE: Tire pressure sensors are equipped with Lithium-ion batteries and must be disposed of accordingly.
1. Remove the tire pressure monitoring system (TPMS) sensor.
2. WARNING: The TPMS band is under tension. Always use safety goggles or a face shield and gloves when removing the TPMS
band/strap. Failure to follow these instructions may result in personal injury.
Remove a factory installed strap in this sequence:
1
Locate the strap buckle and secure the strap to the wheel using duct tape or a similar item, on both sides of the buckle approximately 25 mm
(0.98 inch) from the buckle.
2
Using a large screwdriver and a twisting motion, unbuckle the strap.
3
Discard the strap. To remove a dealer installed strap, turn the worm gear screw until the strap is fully released from the worm gear.
^
Discard the strap.
3. NOTE: To aid assembly, mark the location of the cradle prior to disassembly.
Using a screwdriver, or similar tool, remove the cradle by inserting the screwdriver under the cradle and prying up.
Assembly
1. NOTE: Make sure the sensor is fully seated into the new cradle. The sensor will make a "click" noise when fully seated.
Position the sensor into the new cradle by inserting the hinge end of the sensor into the hook end of the cradle and pushing the opposite end of the
sensor down onto the cradle.
2. CAUTION: Metal scrapers can damage the wheel. Use only plastic or non-metallic scrapers to remove the cradle adhesive strip residue.
NOTE: The sensor and cradle must be installed in the drop well of the wheel, 180 degrees from the valve stem.
Clean the area where the sensor and cradle are to be installed.
