Explorer Sport Trac 4WD V8-4.6L VIN 8 (2007)
6. Disconnect the pressure line-to-pump fitting.
^
Remove and discard the Teflon(R) O-ring seal.
7. Remove the 2 engine wiring bracket nuts and position the wiring harness and ground cable aside.
8. Remove the 3 bolts and the power steering pump.
Installation
1. NOTE: A new Teflon(R) O-ring seal must be installed.
Using the special tool, install a new Teflon(R) O-ring seal on the pressure line-to-pump fitting.
2. Position the power steering pump and install the 3 bolts.
^
To install, tighten to 20 Nm (15 ft. lbs.)
3. Position the ground cable and engine wiring bracket. Install the 2 nuts.
^
Tighten to 20 Nm (15 ft. lbs.)
4. Connect the pressure line-to-pump fitting.
^
Tighten to 65 Nm (48 ft. lbs.)
5. Connect the reservoir-to-pump hose.
6. Install the pressure line bracket-to-engine nut.
^
Tighten to 11 Nm (8 ft. lbs.)
7. Install the power steering pump pulley.
8. Fill the power steering system.
