Explorer Sport Trac 4WD V8-4.6L VIN 8 (2007)
Stabilizer Link: Service and Repair
Front
Stabilizer Bar and Link
Removal and Installation
CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure can
result in major service expense. A new part with the same part number or an equivalent part must be installed, if installation is necessary. Do
not use a part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of correct
retention of these parts.
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Remove and discard the 2 stabilizer bar nuts and grommets.
^
To install, tighten to 35 Nm (26 ft. lbs.) at curb height.
3. Remove and discard the 2 stabilizer bar studs.
4. Remove the 2 stabilizer bar links.
5. NOTE: Inspect and clean the mating surfaces and the internal threads. Make sure all mating surfaces are free of foreign material and remove any
