Explorer Sport Trac 4WD V8-4.6L VIN 8 (2007)
c.
Closely inspect the TFT window for any machining chips and or metallic contamination. (Figure 5)
5.
Prior to installation of the protective strip, remove all machining chips and or other metallic contamination from these areas with a clean, lint free
cloth.
6.
Install the new foam barrier strip over the blades of the TCU, no special barrier strip is required for the TFT. (Figure 2 shows before foam barrier
strip is installed, Figure 6 shows after the foam barrier strip is installed).
7.
Reinstall the TCU on to the main control. Install the six (6) long bolts into the TCM unit. Tighten to 53 lb-in (6 N.m). (Figure 7) Reinstall/verify
the cooler bypass valve (spring end into the case first, "point" down), reinstall pump seal adaptor, and four (4) center support seals following
WSM, Section 307-01.
