Explorer Sport Trac 4WD V8-4.6L VIN 8 (2007)
6. Remove the 4 nuts and remove the selector lever housing from the vehicle.
Installation
NOTE: When installing the selector lever cable, make sure that the selector lever cable locking tabs are locked in place and the cable end is snapped
onto the ball stud. Press the selector lever cable into the bracket and listen for the cable to click in place. Pull back on the selector lever cable to make
sure that it is locked into the bracket. Also make sure that the selector lever cable end is correctly installed onto the ball stud. Pull back on the selector
lever cable end to make sure that the cable end is correctly installed.
1. Install the selector lever housing.
^
Tighten to 9 Nm (80 inch lbs.)
2. Connect the wiring harness to the selector lever housing.
3. Connect the electrical connector.
