Explorer Sport Trac 4WD V8-4.6L VIN 8 (2007)
NOTE: Note where the 8 check balls, 6 solenoid dampers, 2 internal valves and springs and 2 internal filters are located for reassembly.
Mechatronic assembly upper half
1. Make an identifying mark on each solenoid and the corresponding bore for correct assembly.
2. Remove the 6 long bolts from the TCM unit.
3. Carefully separate the TCM from the Mechatronic assembly.
4. Remove 19 short bolts from the Mechatronic assembly.
5. Separate the lower half of the Mechatronic assembly from the upper half of the Mechatronic assembly.
6. Remove and discard the separator plate.
7. Remove from the Mechatronic assembly the clips, caps, valves and spring from each bore. Note the location and order for reassembly. Refer to the
exploded views.
