Explorer Sport Trac 4WD V8-4.6L VIN 8 (2007)
Part 2
Exploded View
Removal and Installation
1. Remove the front door trim panel.
2. Remove the front door speaker.
3. Remove the exterior mirror front door weather shield.
4. Disconnect the exterior mirror electrical connector.
5. Release the 3 door wiring harness pin-type retainers.
6. Remove the front door weather shield.
7. Remove the door trim panel reinforcement screw.
8. Remove the door trim panel reinforcement.
9. CAUTION: Make sure the holes in the glass bracket do not become enlarged during the rivet removal process. If the holes become
enlarged, the new rivets may become loose, resulting in a clicking noise concern.
NOTE: Use a 4.5 mm (0.1772 in) drill bit to drill out the glass-to-regulator rivets.
Remove the 2 front door window glass-to-regulator rivets.
-
Position the front door window glass as necessary to access the front door window glass-to-regulator rivets.
