F 150 2WD V8-4.6L (2008)
Removal
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Drain the engine oil.
3. Remove the cooling fan. For additional information, refer to Cooling System.
4. Remove the RH valve cover.
5. Remove the LH valve cover.
6. Rotate the tensioner clockwise and remove the drive belt.
7. CAUTION: This bolt is torque-to-yield and cannot be reused. Failure to follow these instructions may result in engine damage.
Using the special tool, remove the bolt and washer and discard the bolt.
8. Using the special tool, remove the crankshaft pulley.
9. Using the special tool, remove and discard the crankshaft front seal.
