F 150 2WD V8-4.6L (2008)
16. Connect the power steering pressure tube.
^
Tighten to 65 Nm (48 lb-ft).
17. Position the power steering pressure tube support bracket and install the nut.
^
Tighten to 12 Nm (9 lb-ft).
18. NOTE: If the pulley has been removed and installed twice, install a new power steering pump pulley.
Using the special tool, install the power steering pump pulley.
^
Inspect the pulley for paint marks in the web area near the hub. If there are 2 paint marks, install a new pulley. If there is one paint mark or
none at all, use a pencil to mark the web area of the pulley near the hub.