F 150 2WD V8-4.6L (2008)
19. Install the 3 accessory drive belt idler pulleys and the 3 bolts.
^
Tighten to 25 Nm (18 lb-ft).
20. Install the coolant pump pulley and the 4 bolts.
^
Tighten to 25 Nm (18 lb-ft).
21. Lubricate the engine front cover and the crankshaft front seal inner lip with clean engine oil.
22. Using the special tools, install a new crankshaft front seal.
23. NOTE: If not secured within 4 minutes, the sealant must be removed and the sealing area cleaned with silicone gasket remover and metal surface
prep. Follow the directions on the packaging. Allow to dry until there is no sign of wetness, or 4 minutes, whichever is longer. Failure to follow
this procedure can cause future oil leakage.
Apply silicone gasket and sealant to the Woodruff key slot on the crankshaft pulley.
