F 150 2WD V8-4.6L (2008)
Part 2
Removal
1. CAUTION: While repairing the power steering system, care should be taken to prevent the entry of foreign material or failure of the
power steering components may result.
With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the power steering pump pulley.
3. Remove the steering line clamp plate bolt and rotate the plate.
4. Disconnect the pressure line from the steering gear.
5. Remove the pressure line bracket-to-crossmember bolt.
6. Remove the pressure line bracket-to-engine nut.
7. Disconnect the pressure line-to-pump fitting and remove the pressure line.
Installation
1. Position the pressure line and connect the pressure line-to-pump fitting.
^
If equipped with 4.6L or 5.4L engine, tighten to 65 Nm (48 lb-ft).
^
If equipped with 4.2L engine, tighten to 20 Nm (15 lb-ft).
2. Install the pressure line bracket-to-engine nut.
^
If equipped with a 4.2L or 4.6L engine, tighten the nut to 12 Nm (9 lb-ft).
^
If equipped with a 5.4L engine, tighten the nut to 40 Nm (30 lb-ft).
3. Install the pressure line bracket-to-crossmember bolt.
^
Tighten to 11 Nm (8 lb-ft).
4. Position the pressure line on the steering gear.
5. Rotate the steering line clamp plate and install the bolt.
^
Tighten to 23 Nm (17 lb-ft).
6. Install the power steering pump pulley.
7. Fill the power steering system.
