F 150 2WD V8-4.6L (2008)
4. Remove the RH defrost grille.
5. Remove the 2 pin-type retainers that retain the passenger air bag module deployment door to the instrument panel (if equipped).
6. CAUTION: Do not handle the passenger air bag module by grabbing the edges of the deployment doors. Damage to the air bag module
may occur.
Reaching one hand into the glove compartment opening, push out on the front of the passenger air bag module, releasing the clips at the front of
the bag and partially remove the passenger air bag module from the instrument panel.
7. Disconnect the 2 passenger air bag module electrical connector and remove the passenger air bag module.
Installation
1. Connect the 2 passenger air bag module electrical connectors.
2. NOTE: Make sure the J-clips are in place before positioning the passenger air bag module to the instrument panel.
Position the passenger air bag module into the instrument panel.
1
Angle the rear of the passenger air bag module deployment door so the tabs engage to the instrument panel.
2
Position the passenger air bag module into place and push down on the deployment door, engaging the remaining tabs.
3. Install the RH defrost grille.
4. Install the 2 pin-type retainers that retain the passenger air bag module deployment door to the instrument panel (if equipped).
5. Install the passenger air bag module bolts.
-
To install, tighten to 9 Nm (80 lb-in).
6. Close the glove compartment.
7. Repower the SRS.
