F 150 2WD V8-4.6L (2008)
11. NOTE: When installing the selector lever cable, make sure that the selector lever cable locking tabs are locked in place and the selector lever
cable end is snapped onto the ball stud. Press the selector lever cable into the bracket and listen for the selector lever cable to click in place. Pull
back on the selector lever cable to make sure that it is locked into the bracket. Also make sure that the selector lever cable end is correctly installed
onto the ball stud. Pull back on the selector lever cable end to make sure that the selector lever cable end is correctly installed.
Connect the selector lever cable to the manual control lever and lock the adjuster.
12. CAUTION: Failure to route the selector lever cable in the routing clip can allow the cable to rest on exhaust components causing damage
to the cable.
Route the selector lever cable in the routing clip.
13. Verify the vehicle will start in PARK and NEUTRAL. Verify the reverse lamps illuminate in the REVERSE position. If not, check the adjustment
of the transmission range (TR) sensor.
14. Install the 2 screws and the lower dash panel.
