F 150 2WD V8-4.6L (2008)
6. Disconnect the selector lever electrical connector and remove the selector lever from the vehicle.
Installation
1. Position the selector lever assembly in the console and install the bolts.
^
Tighten to 12 Nm (9 lb-ft).
2. Connect the selector lever harness electrical connector.
3. NOTE: When installing the selector lever cable, make sure that the selector lever cable locking tabs are locked in place and the selector lever
cable end is snapped onto the ball stud. Press the selector lever cable into the bracket and listen for the selector lever cable to click in place. Pull
