F 150 2WD V8-4.6L (2008)
4. Remove and discard all 4 of the snap rings.
5. Place the special tool in a vise.
6. NOTE: If necessary, use a pair of pliers to remove a bearing cup that fails to press out all the way.
Remove the bearing cups and the driveshaft slip yoke.
1
Position the driveshaft slip yoke in the special tool.
2
Press out a bearing cup.
3
Rotate the driveshaft slip yoke 180 degrees.
4
Press on the U-joint spider to remove the remaining bearing cup.
5
Remove the driveshaft slip yoke.
