F 150 2WD V8-4.6L (2008)
Remove the rear glass from the vehicle.
Power sliding rear window
7. Remove the 2 screws from the LH and RH transition blocks.
8. CAUTION: The following substeps are to prevent the cables from popping out of the motor housing. If an existing regulator and motor
assembly is to be reused, do not allow the cables to pop out of the motor housing, as they can unwind from the drum. If the cables unwind
from the drum, a new regulator and motor assembly will have to be installed.
NOTE: LH side shown, RH side similar.
Remove the LH cable first, then the RH side cable. Press and hold the transition block away from the centerline of the vehicle.
9. NOTE: LH side shown, RH side similar.
Clamp and hold the cable near the transition block.
10. NOTE: LH side shown, RH side similar.
Gently pull up the end of the transition block and lift it out of the groove. Do not release the clamp.
11. NOTE: LH side shown, RH side similar.
Slowly release the clamp on the cable to gradually unload the tensioning spring on the motor housing.
