F 150 2WD V8-4.6L (2008)
4. NOTE:
-
LH side shown, RH side similar.
-
While holding the LH cable under tension, cycle the window motor to decrease the freeplay on the RH cable. Reducing the freeplay on the RH
cable will allow ease of installation of the RH cable.
Press the transition block away from the centerline of the vehicle, then snap it into the groove. Release the cable tension spring.
5. NOTE: LH side shown, RH side similar.
The transition block is correctly seated when its top edge is +/- 10 mm (0.39 in) above the top of the window opening.
6. Install the LH and RH transition block screws.
All vehicles
7. Carefully install the rear window glass into the body opening.
8. Install the rear window glass nuts.
-
Tighten to 4 Nm (35 lb-in).
9. If equipped, connect the heated rear backlight electrical connectors.
10. Install the rear trim panel.
11. Install the rear trim panel pin-type retainers.
