F 150 2WD V8-4.6L VIN W (2007)
Keyless Entry Transmitter: Service and Repair
Autolock and Horn Chirp Programming
AUTOLOCK AND HORN CHIRP PROGRAMMING
Using the Keyless Entry Keypad
NOTE:
-
The autolock feature is not available on vehicles equipped with manual transmissions.
-
A manual enable/disable mode allows the autolock feature to be turned off and on.
1. Enter the 5-digit permanent entry code into the keyless entry keypad.
2. Within 5 seconds of entering the code, press and hold the 7/8 button on the keypad.
3. Within 5 seconds of Step 2, and while holding the 7/8 button, press the 3/4 button on the keypad and release it.
4. NOTE: If the autolock feature is disabled, the horn chirps once. If the autolock feature is enabled, the horn chirps once shortly then sounds a
second time for a longer sound of the horn once the above sequence is completed.
Within 5 seconds of Step 3, release the 7/8 button on the keypad.
Using the Ignition Lock Cylinder
NOTE: The autolock feature is not available on vehicles equipped with manual transmissions.
1. Close all the doors.
2. Confirm that the ignition switch is in the OFF position.
3. Turn the ignition switch from OFF to ON.
4. NOTE: Steps 4 through 8 must be carried out within 30 seconds.
Press the door lock control switch UNLOCK button 3 times.
5. Turn the ignition switch from ON to OFF.
6. Press the door lock control switch UNLOCK button 3 times.
7. Turn the ignition switch from OFF to ON.
8. Verify that the horn chirps. This indicates the system is in the enable/disable mode and is ready to accept program changes.
9. Press the door lock control switch UNLOCK button one time to toggle the autolock/relock feature OFF.
10. Press the door lock control switch LOCK button once to enter the command.
11. Verify that the horn chirps 1 time. There should only be 1 chirp indicating that autolock/relock feature is disabled. If 1 chirp is heard, followed by
a longer sound of the horn, the autolock/relock feature has been enabled. Return to Step 9.
12. Turn the ignition switch to the OFF position to exit the enable/disable mode.
13. Exit the vehicle and verify that the horn chirps once to indicate that a feature has been changed and that autolock/relock is disabled.
