F 150 2WD V8-4.6L VIN W (2007)
6. NOTE: LH side shown, RH side similar.
Gently pull up the end of the transition block and lift it out of the groove. Do not release the clamp.
7. NOTE: LH side shown, RH side similar.
Slowly release the clamp on the cable to gradually unload the tension spring on the motor housing.
8. NOTE: LH side shown, RH side similar.
Remove the cable swag from the guide bracket on the sliding rear window.
9. Disconnect the rear window glass motor electrical connector.
10. Remove the rear window glass regulator and motor assembly screws.
11. Remove the rear window glass regulator and motor assembly from the vehicle.
Installation
1. Install the rear window glass regulator and motor assembly to the vehicle.
2. Install the rear window glass regulator and motor assembly screws.
-
Tighten to 11 Nm (8 lb-ft).
3. Connect the rear window glass motor electrical connector.